Sensedge Mini

The Kaiterra Sensedge Mini is a commercial indoor air quality monitor with replaceable sensors.

Specifications

  • Power: AC 100~240V 50/60Hz to DC 5V-2A power adapter / 12~30V direct wiring / customizable for PoE via an external adapter

  • Connectivity: WiFi / Ethernet / Modbus via RS-485

Measurement fields

  • PM2.5

  • TVOC

  • CO2

  • Temperature

  • Relative humidity

  • Customizable modules

Configuration

To access the configuration page of the monitor, follow the steps below:

  1. Power up the monitor

  2. Remove the front panel

  3. Turn the power switch to ON

  4. The monitor will automatically enter the configuration mode for 15 minutes, with the STATUS light blinking in yellow

  5. Open the “Kaiterra Configuration Tool” (download here) on a Windows / Mac OS / Linux computer

  6. Connect your computer to the wireless hotspot created by Kaiterra Sensedge Mini; its SSID (network name) should start with “Kaiterra-SE-200” and is also fully printed on its shell under the front panel

  7. The “Kaiterra Configuration Tool” will detect the monitor and automatically enter its configuration page

You may now set up the monitor on the configuration page according to the following instructions:

  • To gather the information required for adding the monitor to the gams platform, see Monitor Information

  • To connect the monitor to a WiFi network, see WiFi Setup

  • To configure the monitor to send data directly to the gams platform, see MQTT Setup

When you finish configuring the monitor, make sure that Sleep mode is OFF or unchecked and click on Configure Device at the bottom of the window.

Monitor Information

  1. On the “Kaiterra Configuration Tool”, click the Device tab at the top left

  2. At the top of the page, under the Device details section:

  • Its UUID is on the UDID line

  • Its model is on the Model line, e.g. SE-200

WiFi Setup

  1. On the “Kaiterra Configuration Tool”, click the Device tab at the top left

  2. Scroll down the page to find the Wifi section

  3. Under the Wifi section, enter the SSID of the wireless network you wish to connect the monitor to

  4. For the Security option:

    • If the WiFi network does not require a password, select None

    • If the WiFi network requires a password, select the corresponding security protocol (the most common one is WPA/WPA2-PSK), and enter the Password

MQTT Setup

  1. On the “Kaiterra Configuration Tool”, click the Device tab at the top left

  2. Scroll down the page to find the MQTT section

  3. Enter the Broker URI: bridge.measureofquality.com

  4. Enter the Broker port: 1883