#############
Sensedge Mini
#############

The Kaiterra Sensedge Mini is a commercial indoor air quality monitor with replaceable sensors.

Specifications
==============

* Power: AC 100~240V 50/60Hz to DC 5V-2A power adapter / 12~30V direct wiring / customizable for PoE via an external
  adapter
* Connectivity: WiFi / Ethernet / Modbus via RS-485

Measurement fields
------------------

* PM2.5
* TVOC
* CO2
* Temperature
* Relative humidity
* Customizable modules

Configuration
=============

To access the configuration page of the monitor, follow the steps below:

#. Power up the monitor
#. Remove the front panel
#. Turn the power switch to *ON*
#. The monitor will automatically enter the configuration mode for 15 minutes, with the *STATUS* light blinking in yellow
#. Open the "Kaiterra Configuration Tool"
   (`download here <https://support.kaiterra.com/download-kaiterra-configuration-tool>`_)
   on a Windows / Mac OS / Linux computer
#. Connect your computer to the wireless hotspot created by Kaiterra Sensedge Mini; its SSID (network name) should start
   with "Kaiterra-SE-200" and is also fully printed on its shell under the front panel
#. The "Kaiterra Configuration Tool" will detect the monitor and automatically enter its configuration page

You may now set up the monitor on the configuration page according to the following instructions:

* To gather the information required for adding the monitor to the gams platform, see
  :ref:`monitors/kaiterra/sensedge_mini:Monitor Information`
* To connect the monitor to a WiFi network, see :ref:`monitors/kaiterra/sensedge_mini:WiFi Setup`
* To configure the monitor to send data directly to the gams platform, see
  :ref:`monitors/kaiterra/sensedge_mini:MQTT Setup`

When you finish configuring the monitor, make sure that ``Sleep mode`` is *OFF* or unchecked and click on
``Configure Device`` at the bottom of the window.

Monitor Information
-------------------

#. On the "Kaiterra Configuration Tool", click the ``Device`` tab at the top left
#. At the top of the page, under the ``Device details`` section:

  * Its UUID is on the ``UDID`` line
  * Its model is on the ``Model`` line, e.g. ``SE-200``

WiFi Setup
----------

#. On the "Kaiterra Configuration Tool", click the ``Device`` tab at the top left
#. Scroll down the page to find the ``Wifi`` section
#. Under the ``Wifi`` section, enter the ``SSID`` of the wireless network you wish to
   connect the monitor to
#. For the ``Security`` option:

   * If the WiFi network does not require a password, select *None*
   * If the WiFi network requires a password, select the corresponding security protocol (the most common one is
     *WPA/WPA2-PSK*), and enter the ``Password``

MQTT Setup
----------

#. On the "Kaiterra Configuration Tool", click the ``Device`` tab at the top left
#. Scroll down the page to find the ``MQTT`` section
#. Enter the ``Broker URI``: *bridge.measureofquality.com*
#. Enter the ``Broker port``: *1883*