########
Sensedge
########

The Kaiterra Sensedge is a commercial indoor air quality monitor with a touch screen and replaceable sensors.

Specifications
==============

* Power: AC 100~240V 50/60Hz to DC 5V-2A power adapter / customizable for PoE via an external adapter
* Connectivity: WiFi / Ethernet / Modbus / Bacnet

Measurement fields
------------------

* PM2.5
* TVOC
* CO2
* Temperature
* Relative humidity
* Customizable modules

Configuration
=============

To configure the monitor, power it up and operate it with the touch screen according to the following instructions:

* To gather the information required for adding the monitor to the gams platform, see
  :ref:`monitors/kaiterra/sensedge:Monitor Information`
* To connect the monitor to a WiFi network, see :ref:`monitors/kaiterra/sensedge:WiFi Setup`
* To configure the monitor to send data directly to the gams platform, see :ref:`monitors/kaiterra/sensedge:MQTT Setup`

Monitor Information
-------------------

To gather the information required for adding the monitor to the gams platform, follow the steps below:

#. Tap ``Settings`` at the bottom left
#. Tap ``Device Details``
#. On the ``Device Details`` page:

   * Its UUID is available on the ``Unique ID`` line
   * Its model is available on the ``Model`` line, e.g. ``SE-100``

WiFi Setup
----------

To connect the monitor to a WiFi network, follow the steps below:

#. Tap the ``Settings`` button at the bottom left
#. Tap ``WiFi``
#. Set ``Enabled`` to *on* (the button should turn green)
#. Select the network to connect to in the list below
#. Provide the password if required

If the connection was successful, the ``SSID`` line will list the network name
and the WiFi icon at the end of the line will have a green checkmark.

MQTT Setup
----------

To configure the monitor to send data directly to the gams platform, follow the
steps below:

#. Tap the ``Settings`` button at the bottom left
#. Tap ``Device Details``
#. Tap ``Connectivity``
#. Tap ``MQTT``
#. Set the following parameters:

   * ``MQTT Uri``: *bridge.measureofquality.com*
   * ``MQTT Port``: *1883*
   * ``MQTT SSL``: disable (the button should be greyed out)

#. Tap ``Restart Service``

At this point, the log window should show a successful green message stating:

.. code-block::

    Successfully connected:tcp://bridge.measureofquality.com:1883